Nissan GTR-R35 WP20 PLATE DUAL CLUTCH KIT
Our Nissan GTR-R35 WP20 plate dual clutch kits are designed to run 1100+whp, having used the same technology as our WP18 plate dual clutch kits. All the parts on this kit have been re-designed to accommodate 20 friction plates with 20 steel plates, however, we have utilised the same technology as our WP18 plate dual clutch kit, which uses the same steels and frictions as used in the WP18 kit, we have the ability to supply common plates for our entire range of clutches from our WP18 through to the XWP24 clutch.
Important Note
**Please note there are two sizes of piston B, depending on the year of the vehicle, the correct one will need to be fitted**
**Model Year 2009 or Model Year 2012**
**Please note, this kit comes fully assembled and some of the stock parts will be needed to be returned for modification**
It is important to highlight that this kit comes fully assembled and you are fully aware that some of the stock parts will need to be removed from your vehicle and dispatched to our factory for modification. The supplied stock parts will become an integral part of your new WP20 plate clutch.
Nissan GTR-R35 WP20 Plate Dual Clutch kit
Specification
- One-piece billet plate carrier (not welded)
- Basket A (2,4,6) CNC machined from a single billet, no welds, fully heat-treated for durability and strength
- Basket B (1,3,5, R) CNC machined from a single billet, no welds, fully heat-treated for durability and strength
- Piston A, CNC machined from a single billet, no welds
- Piston B, CNC machined from a single billet, no welds
- New clip-in pistons seals, designed for low friction, 100% reliable
- 20 Wide plate frictions, 1.8mm thick, 37% more friction surface area over stock
- 18 Wide steel plates, 1.3mm thick, heat-treated, and surface ground
- 2 Wide steel end plates, 1.6mm thick, heat-treated, and surface ground
- CNC machined billet gear drive plate
- 3 High-quality snap rings
Please Contact +6590029512 For More Purchase Enquiries